Maintenance
We can get some questions about our products and required to maintenance.
If you have some problems that trouble of machine or fix or overhaul and so on, please contact us.
Self-maintenance
These are how to Self-maintenance of machine.
Please watch below videos.
How to check Cutting oil（semi-dry）
Viewing time 60 sec.
- Position of the valve
- How to adjust about air amount
- Position of the cutting oil
- ロックの解除unlock the valve
- Adjust of amount of mist
How to check Cutting oil（oil-mist）
Viewing time 50 sec.
- Position of the valve
- How to adjust about air amount
- Adjust of cutting oil
How to check lubrication oil
Viewing time 57 sec.
- Position of tank of oil
- Take off the cap of tank
- To fill the cutting oil
Position of Timing belt and Clutch in the Turret
Viewing time 1min 14sec.
- Push the stop button
- Take off the cover of Turret
- Check the position of Timing belt
- Check the position of clutch
- Check the position of switch of clutch
How to change of fuse
Viewing time 1min 53sec.
- Check some conditions about fuse that doesn’t work
- There is the fuse under-box the machine
- Turn off the power
- Change the fuse
Position of nameplate
Viewing time 21 sec.
- Confirm to position of name plate(It depend on type of products, mostly There are same position as in this video.)
How to check the pressure gauge
Viewing time 44 sec.
- Confirm to position of pressure gauge
- Adjust scale by screwdriver
- Adjust scale to 0.45~0.5Mpa
Position of FANUC data sheet in the machine
Viewing time 1min 11 sec.
- For Control panel with keyboard
- For Control panel without keyboard
How to adjust about the sensor of stopper
Viewing time 1min 13 sec.
- Confirm to position of sensor
- Loosen the screw and keep slide until On the red light
- Tighten the screw and fixed
- Check of operation
Position of ATC 's sensor and how to adjust it
Viewing time 2min 28 sec.
- Confirm to position of sensor
- Confirm to position of switch of cylinder
- Move the cylinder forward
- Tighten the screw and fixed when the sensor reactionサ
- Same for the rear sensor
How to adjust to position of Tool changer Turret
Viewing time 1min 3sec.
- Confirm to position of green lever handle
- Push the green lever handle
- Adjust of position of Turret by hand
How to left the air out of hose on cutting oil
Viewing time 2min 5sec.
- Take off the hose
- Soak up the air by Syringe and hose.
- Reset the hose
How to adjust to position of spindle orientation
Viewing time 5min 33sec.
- Changing program setting by touch panel
- Adjust of fit of spindle orientation by hand
- Reset program setting by touch panel